The scope of work for this acquisition is but not limited to: Welding Repairs (Aluminum); Ultrasonic Thickness (UT) Shot Inspection; Air Test Inaccessible Voids; Remove, Inspect and Reinstall Rub Rail System and Transom Fenders; Renew Shear Bar Rail Section; Realign Main Engine/Reduction Gear to Shaft; Remove, Renew, and Reinstall Propeller Shaft (s); Renew Stern Tube; Remove, Renew, and Reinstall Propeller (s); Renew or Overhaul Sea Valves; Inspect and Overhaul Duplex Sea Strainers; Renew Fuel Valves; Clean and Inspect Exhaust Piping System (s) (Renew Mufflers); Renew, Inspect, and Reinstall Rudder (s); Preserve and Disinfect Potable Water Tanks - 100%; Clean and Inspect Gray Water Holding and Sewage Tanks; Renew Starboard Stern Tube and Strut <CSMP-2008002>; Routine Drydocking; Provide Temporary Logistics; Preserve Underwater Body - "Partial"; Preserve Underwater Body - 100%; Preserve Freeboard - 100%; Preserve Weather Decks; Preserve Superstructure; Renew Shower Deck <CSMP-2008003>.
All welding and brazing shall be accomplished by trained welders who have been certified by the applicable regulatory code performance qualification procedures. At the present time, this acquisition is expected to be issued as a Small Business set- aside. However, in accordance with FAR 19.1305, if your firm is HUBZone certified or 19.1404 if you firm is SDVOSB and intends to submit an offer on this acquisition, please respond by e-mail to [email protected] or by fax (757) 628-4675. Questions may be referred to Dottie Rawls at (757) 628-4636. In response please include the following: (a) a positive statement of your intent to submit a bid for this solicitation as a prime contractor; (b) evidence of experience in work similar in type and scope to include contract numbers, project titles, dollar amounts, points of contact and telephone numbers; (c) past performance references with points of contact and phone numbers. At least two (2) references are requested, but more are desirable. Contractors are reminded that should this acquisition become a HUBZone set aside or SDVOSB Small Business, FAR 52.219-3, Notice of Total HUBZone Set-Aside or 52.219-27, Notice of Total Service-Disabled Veteran-Owned Small Business Set-Aside, will apply, which requires that at least fifty (50) percent of the cost of personnel for contract performance be spent for employees of the concern or employees of other HUBZone small business concerns. Your response is required by 27 January 2010, 12:00 p.m. (EST). All of the above must be submitted in sufficient detail for a decision to be made on a HUBZone, Service-Disabled Veteran-owned Small Business, or Small Business set aside. Failure to submit all information requested may result in an unrestricted acquisition. A decision on whether this will be pursued as a HUBZone, SDVOSB small business set aside, or a Small Business set aside, will be posted on the FedBizOps website at https://fbo.gov.