The acquisition is to perform drydock and repairs to the USCGC KITTIWAKE (WPB-87316) and the USCGC AHI (WPB-87364), all 87' Work Patrol Boats. The government may award one or multiple contracts as a result of the solicitation. Contractors will be allowed to submit quotes for one or multiple vessels.
The vessels are homeported in Honolulu, HI.

All work will be performed at the contractor's facility. The vessels are geographically restricted within the state of Hawaii, HI. The performance period is as follows:

USCGC KITTIWAKE, January 12, 2012 - Mar 02, 2012, fifty-nine (59) calendar days
USCGC AHI, July 11, 2012 - Aug 24, 2012, forty-five (45) calendar days

The scope of the acquisition is for the overhauling, renewing and repairing of various items aboard the USCGC KITTIWAKE, and USCGC AHI. This work may include, but is not limited to:

Perform Ultrasonic Thickness Measurements
Perform Ultrasonic Thickness Measurements
Bilge Surfaces (Lazarette),Preserve, 100%
Bilge Surfaces (Engine Room), Preserve, Partial
Dirty Oil Tank, Clean and Inspect
Oily Water Tank, Clean and Inspect
Tanks (MP Fuel Service), Clean and Inspect
Superstructure, Preserve, 100%
Pilothouse Deck (Aluminum), Inspect, Preserve, and Renew Electrical Matting
Depth Sounder, Capastic Fairing, Renew
Weather Tight Door, Fuel Station, Install (TCTO TB6000)
Mast, Preserve, 100%
Main Engine/Reduction Gear, Realign
Propulsion Shafts, Remove, Inspect, and Reinstall
Propulsion Shaft, Repair
Propulsion Shaft, Straighten
Intermediate Water-Lubricated Shaft Bearing, Renew
Aft Water-Lubricated Shaft Bearing, Renew
Intermediate Bearing Carrier, Renew
Aft Bearing Carrier, Renew
Stern Tubes, Interior Surfaces, Preserve 100%
Stern Tubes, Interior Surfaces, Repair
Propellers, Remove, Inspect, and Reinstall
Propeller, Minor Repair and Recondition, Perform
Fathometer Transducer, Renew
Speed Log, Transducer and Skin Valve, Clean and Inspect
Sea Water System (Valves, Strainers, Piping), Clean, Inspect, and Repair
Rudder Assemblies, Remove, Inspect, and Reinstall
RHIB Notch Skid Pads, Inspect
RHIB Notch Skid Pad Studs, Renew
Stern Launch Door, Remove, Inspect, and Reinstall
Grey Water Holding Tank, Clean and Inspect
Sewage Holding Tank, Clean and Inspect
Grey Water Piping, Clean and Flush
Sewage Piping, Clean and Flush
U/W Body, Preserve, 100%
U/W Body, Preserve, Partial - 33%
Hull Plating Freeboard, Preserve, Partial
Cathodic Protection / Zincs, Renew
Interior Deck Covering System, Reseal
Drydocking
Temporary Services, Provide
Telephone Service, Provide
Install Dirty Oil Tank Level Indicator (EC 087-B-039)

All welding and brazing shall be accomplished by trained welders, who have been certified by the applicable regulatory code performance qualification procedures.

In accordance with FAR 19.502, 19.1305 and FAR 19.1405, if your firm is a small business, HUBZone certified or a Service-Disabled Veteran-Owned Small Business and intends to submit an offer on this acquisition, please respond via in a letter either by e-mail to [email protected] or by fax at (757) 628-4676. Your response you must include the following:

(a) A positive statement of your intention to submit a quote for this solicitation as a prime contractor.

(b) The name of the cutter(s) which you intend to submit a quote.

(c) Evidence of experience in work similar in type and scope to include contract numbers, project titles, dollar amounts, points of contact and telephone numbers; (d) past performance references with points of contact and telephone numbers.

At least two references are requested, but more are desirable.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Your response is due on 05 October 2011, at 4:30 p.m. Eastern Standard Time.

Contractors are reminded that should this acquisition become a HubZone, Service Disabled Veteran Owned or a Small Business set aside that at least 50 percent of the cost of personnel for contract performance be spent for employees of the concern.

All of the above must be submitted in sufficient detail for a decision to be made on a HUBZone, Service Disabled Veteran-Owned Small Business set aside, or Small Business set-aside.
Failure to submit all information requested may result in an unrestricted acquisition. A decision on whether this will be pursued as a HUBZone, SDVOSB set-aside, or small business set-aside, will be posted in the Fedbizopps website at http://www.fedbizopps.gov. Questions may be referred to Ms. Susan Kreider at (757) 628-4644.