Federal Bid

Last Updated on 22 Dec 2011 at 9 AM
Solicitation
Location Unknown

84--Isolation Gowns

Solicitation ID VA79711RP0196
Posted Date 08 Aug 2011 at 4 PM
Archive Date 22 Dec 2011 at 5 AM
NAICS Category
Product Service Code
Set Aside No Set-Aside Used
Contracting Office Nac Federal Supply Schedule (36f797)
Agency Department Of Veterans Affairs
Location United states
PRESOLICITATION NOTICE: The VA National Acquisition Center will issue Request for Proposal (RFP) VA-797-11-RP-0196 for the Department of Veterans Affairs (VA) for Isolation Gowns. VA purchases approximately 57,477 of these Isolation Gowns on an annual basis. Only one award will be made as a result of this solicitation. The Isolation Gowns are being procured as an SDVOSB set-aside. Therefore, all offerors products must be manufactured by a small domestic (or "outlying area") manufacturer. Outlying areas include Commonwealths: (i) Puerto Rico (ii) The Northern Mariana Islands. Territories: (i) American Samoa (ii) Guam (iii) U.S. Virgin Islands; and Minor outlying islands (i) Baker Island (ii) Howland Island (iii) Jarvis Island (iv) Johnston Atoll (v) Kingman Reef (vi) Midway Islands (vii) Navassa Island (viii) Palmyra Atoll (ix) Wake Atoll. Specifications for Isolation Gowns are as follows: Gown, Isolation, Reusable-Large 1 Fabric Content: One Ply 100% Polyester Fiber with Carbon Filament to reduce static discharge. Gown must have a water repellency with a rating of no less than 90 rating according to AATCC 22-1980 and a water resistance according to the AATCC 127-1980 rating of no less than 80 2 Fabric Color-Yellow 3 Labeled (Size, Fabric Content, Care Instructions, Country of Manufacture) 4 Label Fabric either nylon or polyester or painted in labeling 5 Fabric can be commercially laundered 6 Fabric must allow sterilization either by autoclaving or gas 7 Binded Neck 8 Overlap not less than 12in. at waist closing 9 Open Sweep (measured across bottom edge of gown) range 54" to 56" 10 Center back Length - Range 38" to 40" Measured by folding gown in half (length wise) and measuring the collar to the bottom finished edge of gown 11 Sleeve Length (measured from arm pit seam to finished cuff hem where cuff attached to gown)Range 17" to 18" 12 Cuff Length (measured from hem of polyester gown to end of cuff) range 3" to 4" 13 Cuff Circumference range 4" to 6" measured unscratched with cuff flat across the center then taken times 2 14 Cuff Fabric: 100% Kitted Cotton or 50/50 Knitted Cotton/Poly 15 Neck Circumference-range 22" to 24" measurement of collar that goes around the neck 16 Neck tie Lengths - range 12" to 14" Measured from where it is attached to the end of the tie 17 Waist Tie Lengths range 12" to 14" Measured from where it is attached to the end of the tie 18 Ties made of non-curling twill tape 19 Ties are heat sealed, non-raveling 20 Fabric free of runs, pulls, and holes 21 Thread color matches or blends 22 Stitches are free from tangles, knots and skipped or broken stitches 23 Seams are safety stitched/serged 24 There are no openings in seams 25 Seams eased and smooth; free from bulk or puckering 26 All ties are bartacked where they attach to gown across the entire tie to assure strength of tie 27 Stress points (where seams intersect or ties connect) are bartacked 28 No Loose threads 29 Finished hem edges 30 Wash Grid with minimum 75 washings Intended Use: To be used as a PPE for Isolation Cases or possible contaminated procedures. Gown, Isolation, Reusable-Extra Large 1 Fabric Content: One Ply 100% Polyester Fiber with Carbon Filament to reduce static discharge. Gown must have a water repellency with a rating of no less than 90 rating according to AATCC 22-1980 and a water resistance according to the AATCC 127-1980 rating of no less than 80 2 Fabric Color - Yellow 3 Labeled (Size, Fabric Content, Care Instructions, Country of Manufacture) 4 Label Fabric either nylon or polyester or painted in labeling 5 Fabric can be commercially laundered 6 Fabric must allow sterilization either by autoclaving or gas 7 Binded Neck 8 Overlap not less than 12 in at waist closing 9 Open Sweep (measured across bottom edge of gown) 58" to 60" 10 Center back Length - Range 41" to 43" Measured by folding gown in half (length wise) and measuring from the color to the bottom finished edge of gown 11 Sleeve Length (measured from arm pit seam to finished cuff hem where cuff attached to gown) Range 18" to 19" 12 Cuff Length (measured from hem of polyester gown to end of cuff) range 3" to 4" 13 Cuff Circumference range 6" to 8" Measured unstretched with cuff flat across the center then taken times 2 14 Cuff Fabric: 100% Knitted Cotton or 50/50 Knitted Cotton/Poly 15 Neck Circumference - range 24" to 26" measurement of collar that goes around the neck 16 Neck Tie Lengths - range 12" to 14" Measured from where it is attached to the end of the tie 17 Waist Tie Lengths range 12" to 14" Measured from where it is attached to the end of the tie 18 Ties made of non-curling twill tape 19 Ties are heat sealed, non-raveling 20 Fabric free of runs, pulls and holes 21 Thread color matches or blends 22 Stitches are free from tangles, knots, and skipped or broken stitches 23 Seams eased and smooth; free from bulk or puckering 24 There are no openings in seams 25 Seams eased and smooth; free from bulk or puckering 26 All ties are bartacked where they attach to gown across the entire tie to assure strength of tie 27 Stress points (where seams intersect or ties connect) are bartacked 28 No Loose threads 29 Finished hem edges 30 Wash Grid with minimum 75 washings Intended Use: To be used as a PPE for Isolation Cases or possible contaminated procedures. If you submitted a bid and samples for the previous solicitation for this item (VA-797-11-RP-0058) you DO NOT have to submit more samples, but you will have to fill out the new solicitation document and submit it by the closing date. You may make pricing changes if necessary. Solicitation #VA-797-11-RP-0196 will be electronically issued in commercial item format, in accordance with FAR Part 12, on or about August 23, 2011. The solicitation will be open for 30 days. Interested offerors are advised to continuously check URL: http://www.fedbizopps.gov for any changes to the solicitation. Any future Amendments or other information regarding this solicitation will be available on that site as well. The point of contact is Amber Zavala, Contracting Officer. Please e-mail all questions or inquiries to [email protected].
Bid Protests Not Available